Curved walls

[Carolyn Zapedzki]

Is there an easy way to hang say a poster on a curved wall?

I usually just mess about with rotation but it's a bit of a PITA if you want to hang a lot of things and wondered if there's an easier way or some sort of formula that speeds things up.

[SarahKB7 Koskinen]

Why not make the poster curved too?

A hollowed sphere or cylinder prim interior/exterior surface could be cut, sliced and stretched to match the curved wall surface. Then the poster texture settings would need to be realigned to match the prim interior/exterior.

Edited April 1 by SarahKB7 Koskinen

[Carolyn Zapedzki]

3 hours ago, SarahKB7 Koskinen said:

Why not make the poster curved too?

A hollowed sphere or cylinder prim interior/exterior surface could be cut, sliced and stretched to match the curved wall surface. Then the poster texture settings would need to be realigned to match the prim interior/exterior.

I will give that a go, they should still look fine on a straight wall as well? It's for stuff I sell.

Thank you.

Edited April 1 by Carolyn Zapedzki

[ChinRey]

2 hours ago, Carolyn Zapedzki said:

I will give that a go, they should still look fine on a straight wall as well? It's for stuff I sell.

You can simply include both a flat and a curved copy of the poster in the package you sell

Edited April 1 by ChinRey
typo