RLV detect parametrized restriction?

[primerib1]

Okay so let's say my HUD wants to check if there's a mouselook restriction, invoked using:

@camdistmax:0=n

Can I specify the ":0" part in the getstatus / getstatus RLV command?

So I send a message like these (assuming 2222 is the channel I'm using to listen to RLV responses:

@getstatus:camdistmax:0=2222
@getstatusall:camdistmax:0=2222

Is that allowed?

Or am I limited to just specifying "camdistmax" and have to parse the result to see if there are any ":0" in the result?

[Wulfie Reanimator]

Sure you can.

Did you know there's an RLVa console where you can type in the commands and see the results? (The restrictions set in the console are cleared when the console is closed.)

(I used channel 0 for the output so it can be seen in the console itself.)

Edited February 21, 2023 by Wulfie Reanimator