Jump to content

How to run multiple prims at the same time


phithanh
 Share

You are about to reply to a thread that has been inactive for 4156 days.

Please take a moment to consider if this thread is worth bumping.

Recommended Posts

Hi, the trick is all in the alignment. Set your hollows on the same axis and rotation, carefully measure the drive shaft to match the hollows, and you should get a good snug fit to power several prims on a single power source. If you need to run more than 3 or 4 prims, it will be good to hire a precision machinist, but smaller loads can handle looser tolerances.

crank.jpg

Link to comment
Share on other sites

You are about to reply to a thread that has been inactive for 4156 days.

Please take a moment to consider if this thread is worth bumping.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

×
×
  • Create New...