Mono script refuses to Save

[Phil Deakins]

As I was doing work on a script, saving everything as I went along, all was well - until part way through today, when suddenly I could no longer save changes to it. I tried saving a different script and it was ok, but not the main script. The error message simply told me that it can't be saved and that I should try again later. That script always produces that error message, whereas other scripts don't have a problem.

Some time later I tried again, and had the same problem. I tried creating a new script and putting the main one's content into it, but that wouldn't save either. Then I accidentally discovered that it saves fine when it's not mono, so it's only saving in mono where there's a problem with that script.

It could be that this problem is very uncommon but, if anyone has any ideas, I'd love to hear them.

 

[Phil Deakins]

Cancel the above post. I'd made a mistake. I'd used 'jump' in 2 places in the script, which was fine, but they both jumped to @out, which was not.