MachiniCam Beta 2

[Ohjiro Watanabe]

Hello again,

Firstly, thanks for all the feedback from the last beta release, it was really helpful!

I have just released a new beta version of MachiniCam screen recording software and I am looking for some beta testers.

If you can spend a little time testing and send me some feedback I would be very grateful.

Download here and use the link in the software to send feedback. Details of the changes are also on the website.

If you do I will give you a small reward. I have another tool for helping get great shots in world. It is a virtual joystick that will enable you to steer your camera as if you are using a joystick, it maps your numeric keypad to the Flycam controls in your viewer. It enables you to smoothly pan right/left, up/down, forward/backward, turn left/right pan up/down and roll left/right and you can use them all in combination. This is free software,no time limit. More info here: vJoy VW. Send me feedback on MachiniCam using the link in the software and I will send you the download link to vJoy VW.

 

Ohjiro Watanabe

[Ly Jie]

Here is an example using MachiniCam to record and vJoy VW to control the camera.

 

 

 

 

 

[Lay Boa]

Cool, very easy to use. When do you plan to release the full version?

[Ly Jie]

Wow! Looks realy crisp Kandy, well done

[Ohjiro Watanabe]

The installation has to register a filter which requires adminstrator rights so please run the setup As Administrator.